- You are not logged in.
Announcement
Register to remove this pesky message!
#1 2007-11-19 20:47:30
- DereckT
- New member
- Reputation : [+ 0/ -0 ]
Saitek X45 Joystick
I am using an Advenr Quad processor with Vista. Joystick side of my X45 is working fine but on the throttle side both the rudder control and throttle are operating like switches - either off or full on. There is no gradation. Also, I am unable to assign either of the rotary switches. Any advice gratefully received. Thanks.
Dereck
Offline
#2 2007-11-20 11:38:09
- rbcoomer
- Administrator
- Reputation : [+ 1/ -0 ]
Re: Saitek X45 Joystick
Hi Dereck,
I'm not familiar with that controller and thus don't have one here to test on Vista but it sounds like a driver problem. The inputs are being recognised by Vista as switches which suggests that the mapping of the device is wrong. Have you downloaded & installed the latest drivers from Saitek's website? Whilst Vista usually recognises these devices automatically, the manufacturers drivers are usually better and more recent. Is there a calibration option for this controller in the control panel? The inputs are possibly user configurable/assigned... If so, make sure those controls are set as analogue.
Regards,
Robin
WebmasteR-)
Offline
#3 2009-05-24 23:36:48
- jonj0e
- New member
- Reputation : [+ 0/ -0 ]
Re: Saitek X45 Joystick
oioi DereckT , dont know if you have managed to sort your prolem out with the x45 , if not then try on the saiteck site and down load the latest drivers this may solve your problem it worked for me hope u have the same luck here is the link http://www.saitek.com/uk/down/drivers.htm
hope u get sorted jonj0e.........
Offline
